Constant Power Mode; Rectified Load Mode - Chroma 63800 Series Operation & Programming Manual

Users can change the orders of the measurement parameters arbitrarily
under CONF/LOCAL  4. DISPLAY SELECTION, please refer section 3.4.1
Setting the Configuration.

4.2.4 Constant Power Mode

There are five measurement values under CP mode: V, I, P, V
are shown as pages below.
Main page:
P s e t = 2 5 0 0 . 0 0 W
V = 0 . 0 0
I = 0 . 0 0
D C
Second page:
P s e t = 2 5 0 0 . 0 0 W
V o v e r s h o o t
V u n d e r s h o o t = 0 . 0 0
D C
Users can change the orders of the measurement parameters arbitrarily
under CONF/LOCAL  4. DISPLAY SELECTION, please refer section 3.4.1
Setting the Configuration.

4.2.5 Rectified Load Mode

There are four measurement values under Rectified mode: V, I, P, and I
as pages below.
I p ( m a x ) = 1 0 0 . 0 0 A
P = 0 . 0 0
I p ( m a x ) = 1 0 0 . 0 0 A
= 0 . 0 0
Measurements
, and V
overshoot undershoot
. They are shown
p
. They


4-11