Quick Setup Via Quick Menu; Parameter Selection; Menu Mode; Parameter Groups - Danfoss VLT Brook Crompton Motor FCM 300 Design Manual

Table of Contents

Advertisement

Programming
However, some parameters will be "missing",
depending on the choice of configuration
(parameter 100), e.g. open loop hides all the PID
parameters.
In addition to having a name, each parameter is linked up
3
3
with a number which is the same regardless of the
programming mode. In the Menu mode, the parameters
are divided into groups, with the first digit of the
parameter number (from the left) indicating the group
number of the parameter in question.
Regardless of the mode of programming, a change of a
parameter will take effect and be visible both in the Menu
mode and in the Quick menumode.

3.1.12 Quick Setup via Quick Menu

The Quick Setup starts with pressing the [Quick Menu] key,
which brings out the following read-out on the display:
QUICK MENU X OF Y
50.0 Hz
001 LANGUAGE
ENGLISH
At the bottom of the display, the parameter number and
name are given together with the status/value of the first
parameter under Quick Setup. The first time the [Quick
Menu] key is pressed after the unit has been switched on,
the read-outs will always start at pos. 1 - see Table 3.6.

3.1.13 Parameter Selection

The selection of parameter is effected by means of the
[+]/[-] keys. The following parameters are accessible:
Pos.:
No.:
1
001
2
200
3
101
4
204
5
205
6
207
7
208
8
002
9
003
32
VLT
SETUP
1
Parameter:
Unit:
Language
Direction of rotation
Torque characteristic
Min. reference
[Hz]
Max. reference
[Hz]
Ramp up time
[s]
Ramp down time
[s]
Local/remote control
Local reference
MG03BA02 - VLT
®
DriveMotor FCM Series
Pos.:
No.:
10
500
Table 3.6 Parameter Selection

3.1.14 Menu Mode

The Menu mode is started by pressing the [Menu] key,
which produces the following read-out on the display:
FREQUENCY
50.0 Hz
0
Illustration 3.8
Line 3 on the display shows the parameter group number
and name.

3.1.15 Parameter Groups

In the Menu mode the parameters are divided into groups.
Selection of parameter group is effected by means of the
[<][>] keys.
The following parameter groups are accessible:
Group no.
0
1
2
3
4
5
6
*For information on parameter group 800 and 900 for PROFIBUS,
please see the FCM Profibus manual MG03EXYY.
Table 3.7
®
is a registered Danfoss trademark
Parameter:
Unit:
Bus address
KEYB.&DISPLAY
Parameter group
Operation & Display
Load & Motor
References & Limits
Inputs & Outputs
Special functions
Serial communication
Technical functions

Advertisement

Table of Contents
loading

Table of Contents