Danfoss VLT Brook Crompton Motor FCM 300 Design Manual page 70

Programming
Bit 11, No function/relay 123, digital output terminal 9
Bit 11 = "1" will activate relay 123 (provided parameter 323
= "Control word bit 11") and set digital out terminal 9 high
(provided parameter 340 = "Control word bit 11").
3 3 Bit 12, No function/relay 123
Bit 12 = "1" will activate relay 123 (provided parameter 323
= "Control word bit 12").
Bit 13, Choice of set-up
Bit 13 is used for choosing between the two menu set-ups
in accordance with the following table:
Setup
1
2
Table 3.28
This function is only possible if Multi-Set-ups have been
selected in parameter 004.
NOTICE
Parameter 507 is used for choosing how Bit 13 is to be
combined (gated) with the corresponding function on
the digital inputs.
Bit 15, No function/reversing
Reversing of the direction of rotation of the motor.
Bit 15 = "0" leads to no reversing. Bit 15 = "1" leads to
reversing.
NOTICE
Unless otherwise mentioned, the control word bit is
combined (gated) with the corresponding function on
the digital inputs as a logic "or" function.
68
®
VLT DriveMotor FCM Series
Bit 13
0
1
®
MG03BA02 - VLT is a registered Danfoss trademark
Status word under FC Profile
The status word is used for informing the master (e.g. a PC)
about the condition of the slave (FC motor).
Bit Bit = 0
00 Control not ready
01 FC not ready
02 Coasting
03 No fault
04 Reserved
05 Reserved
06 Reserved
07 No warning
Speed ≠ ref.
08
09 Local control
10 Out of range
11 Not running
12
13 Voltage OK
14 Current OK
15 Timer OK
Table 3.29
Bit 01, FC not ready/ready
Bit 01 = "0" means that the frequency converter has
tripped.
Bit 01 = "1" means that the frequency converter is ready.
Bit 02, Coasting/enable
Bit 02 = "0" means that the control word bit 03 is "0"
(Coasting) or that the FC motor has tripped.
Bit 02 = "1" means that control word bit 03 is "1" and that
the FC motor has not tripped.
Bit 03, No fault/trip
Bit 03 = "0" means that FCM 300 Series is not in a fault
condition.
Bit 03 = "1" means that FCM 300 Series has tripped and
needs a reset signal in order to run.
Bit 07, No warning/warning
Bit 07 = "0" means that there is no unusual situation.
Bit 07 = "1" means that an abnormal condition has arisen
for the FC motor. All warnings described in4.2 List of
Warnings and Alarms - FCM 300 Design Guide will set bit 07
to "1".
Bit 08, Speed ≠ ref/speed. = ref.
Bit =1
Ready
Ready
Enable
Trip
Warning
Speed = ref.
Bus control
Frequency OK
Running
Above limit
Above limit
Thermal warning