Danfoss VLT Brook Crompton Motor FCM 300 Design Manual page 15

Installation
Max. terminal load (DC1) (IEC 947) on 1-3, 1-2
Min. terminal load (AC/DC) on 1-3, 1-2 control card
Rated values for up to 300,000 operations (at inductive loads the number of operations is reduced by 50%)
Control card, RS 485 serial communication
Terminal nos.
Control characteristics (frequency converter)
Frequency range
Resolution on output frequency
System response time
Speed accuracy (open loop, CT mode, 4 P motor driven in speed range 150-1500 rPm)
Externals
Enclosure
Vibration test
Max. relative humidity
Ambient temperature
See 4.1.7 Derating for Ambient Temperature
Min. ambient temperature in full operation
Min. ambient temperature at reduced performance
Temperature during storage/transport
Max. altitude above sea level
See 4.1.8 Derating for Air Pressure
EMC standards applied, Emission
EMC standards applied,
Immunity
Safety standards applied,
NOTICE
The normal IP 66 solution is only intended for speed up to maximum 3000 rpm. If higher speed is needed, notify when
ordering.
®
VLT DriveMotor FCM Series
See 4.1 Special Conditions for frequency range for IP 66 motors at the end of this section.
See 4.1 Special Conditions for frequency range for IP 66 motors at the end of this section.
EN 61000-6-3/EN 6100-6-4, EN 61800-3, EN 55011, EN 55014
EN 61000-6-2, EN 61000-4-2, EN 61000-4-3, EN 61000-4-4, EN 61000-4-5, EN 61000-4-6,
®
MG03BA02 - VLT is a registered Danfoss trademark
25 V DC, 3A/50 V DC, 1.5 A , 75 W
24 V DC, 10 mA/24 V AC, 100 mA
Max. 40 ms.
IP 55 (IP65, IP66)
95% for storage/transport/operation
Max. 40° C (24-hour average max. 35° C)
-25-+65/70° C
EN 60146, EN 50178, EN 60204, UL508
2 2
X100-1, -2
0-132 Hz
0.1%
±15 rpm
1 g
0°C
-10° C
1000 m
ENV 50204
13