Leds; Control Keys; Control Key Functions - Danfoss VLT Brook Crompton Motor FCM 300 Design Manual

Programming
1st line shows up to 3 measurements continuously in
normal operating status or a text which explains the 2nd
line.
2nd line shows a measurement with related unit contin-
uously, regardless of status (except in the case of alarm/
warning).
3rd line is normally blank and is used in the menu mode
to show the selected parameter number or parameter
group number and name.
4th line is used in operating status for showing a status
text or in data change mode for showing the value of the
selected parameter.
Illustration 3.3
An arrow indicates the direction of rotation of the motor.
Furthermore, the Set-up which has been selected as the
Active Setup in parameter 004 is shown. When
programming another Set-up than the Active Set-up, the
number of the Set-up which is being programmed will
appear to the right. This second Set-up number will flash.

3.1.5 LEDs

At the bottom of the control panel is a red alarm LED and
a yellow warning LED, as well as a green voltage LED.
Illustration 3.4
If certain threshold values are exceeded, the alarm and/or
warning lamp lights up together with a status and alarm
text on the control panel.
The voltage LED is activated when the FC motor receives
voltage; at the same time the rear lighting of the display
will be on.

3.1.6 Control Keys

The control keys are divided into functions. This means
that the keys between display and indicator LEDs are used
for parameter Setup, including choice of display indication
during normal operation.
®
VLT DriveMotor FCM Series
Illustration 3.5
Keys for local control are found under the indicator LEDs.
Illustration 3.6

3.1.7 Control Key Functions

Table 3.1
®
MG03BA02 - VLT is a registered Danfoss trademark
[DISPLAY/STATUS] is used for selecting
the mode of display or for changing back
to Display mode from either the Quick
menu mode or the Menu mode.
[QUICK MENU] is used for programming
the parameters that belong under the
Quick menu mode. It is possible to switch
directly between Quick menu mode and
Menu mode.
[MENU] is used for programming all
parameters. It is possible to switch
directly between Menu mode and Quick
menu mode.
3 3
29