Danfoss VLT Brook Crompton Motor FCM 300 Design Manual page 29

Installation
Functions/settings
Default - Dual speed operation (connect purple
wire):
No changes to factory setting.
Function 2 - Dual mode operation (connect
purple wire):
Select desired modes of operation in Setups 1
and 2 (use para. 4-6) Parameter 335 = 18 (select
Setup)
Function 3 - Dual direction operation (connect
grey wire):
Parameter 335 = 10 (start reversing) Parameter
200 = 1 (both directions)
Table 2.25
*If no reset is required, do not connect the brown wire
**or set parameter 213
Use the [+[/[-] keys to set reference
At power up the unit will always be in stop mode. Set
reference will be stored during power down. If permanent
start mode is desired, connect terminal 6 to terminal 4 and
do not connect purple/grey wire to terminal 4. This means
the stop function on LOP is disabled.
®
VLT DriveMotor FCM Series
Key I (Start)
Run on set reference
(+/-)
Run with Setup 1
Run forward
NOTICE
After fitting, cut off or isolate excess wire.
®
MG03BA02 - VLT is a registered Danfoss trademark
Key II (Start)
Run on 10 Hz** jog Stop (and reset* - if trip)
speed
Run with Setup 2 Stop (and reset* - if trip)
Run reverse Stop (and reset* - if trip)
Key (Stop)
2
27
2