Ordering; Pc Software Tools - Danfoss VLT Brook Crompton Motor FCM 300 Design Manual

Introduction

1.4.3 Ordering

Take a copy of the ordering form, see 1.4.1 Ordering Form.
Fill in and post or fax your order to the nearest branch
office of the Danfoss sales organisation. On the basis of
your order, the FCM 300 Series motor is given a type code.
The ordering form for the basic unit must always be
completed. When the type code is written, always state the
characters of the basic string (1-34). Together with the
order confirmation the customer receives an 8-figure code
number to be used when reordering.
Danfoss PC software for serial communication, MCT 10
All FCM 300 Series units have an RS 485 port as standard,
which enables them to communicate e.g. with a PC. A
programme entitled MCT 10 is available for this purpose
(see 1.4.4 PC Software Tools ).
Ordering numbers, MCT 10
Use code number 130B1000 for ordering the CD
containing MCT 10 Set-up Software.
Accessories for the FC motor
A Local Operation Pad (LOP) for local set point and start/
stop is available for the FC motor. The LOP is IP 65
enclosed. A Local Control Panel (LCP 2) which makes up a
complete interface for operation, programming and
monitoring of the FC motor is also available.
Ordering numbers, accessories
Local Operation Pad incl. cable (LOP)
Local Control Panel (LCP 2)
Remote mounting kit (LCP 2)
Plug kit (LCP 2)
Cable for plug kit (LCP 2)
Cable (direct mounting) (LCP 2)
Service plug kit (LCP 2)
Potentiometer option
Table 1.5
®
VLT DriveMotor FCM Series

1.4.4 PC Software Tools

PC Software - MCT 10
All frequency converters are equipped with a serial
communication port. Danfoss provides a PC tool for
communication between PC and frequency converter, VLT
Motion Control Tool MCT 10 Set-up Software.
MCT 10 Set-up Software
MCT 10 has been designed as an easy to use interactive
tool for setting parameters in our frequency converters.
The MCT 10 Set-up Software will be useful for:
The MCT 10 Set-up Software Modules
The following modules are included in the software
package:
175N0128
175N0131
175N0160
175N2545
175N0162
175N0165
175N2546
Illustration 1.4
177N0011
®
MG03BA02 - VLT is a registered Danfoss trademark
•
Planning a communication network off-line. MCT
10 contains a complete frequency converter
database
•
Commissioning frequency converters on line
•
Saving settings for all frequency converters
•
Replacing a drive in a network
•
Expanding an existing network
•
Future developed drives will be supported
1 1
9