Table of Contents
Advertisement
Programming
3 Programming
3.1 Parameters
3
3
3.1.1 Control Panel (175NO131)
The FC motor optionally features a Local Control Panel-
LCP 2 which makes up a complete interface for operation
and monitoring of the FC motor.
IP 65 on front.
3.1.2 LCP Installation
The LCP 2 is connected to the terminal X100, 1-4 (see
separate instruction MI03AXYY).
1.
Service Plug Kit (175N2546) (see 2.3.1 Service Plug
Kit (175N2546)) and cable 175N0162
2.
Plug kit (175N2545) (see 2.3.2 Plug Kit
(175N2545)) and cable 175N0162
3.
Remote mounting kit (175N0160) (see 2.3.4
Remote Mounting Kit Cont.)
3.1.3 LCP Functions
The functions of the control panel can be divided into
three groups:
•
Display
•
Keys for changing program parameters
•
Keys for local operation
All data are indicated by means of a 4-line alphanumeric
display, which in normal operation is able show 4
measurements and 3 operating conditions continuously.
During programming, all the information required for
quick, effective parameter Set-up of the FC motor will be
displayed. As a supplement to the display, there are three
LEDs for voltage, warning and alarm. All program
parameters of the FC motor can be changed immediately
from the control panel, unless this function has been
blocked via parameter 018.
28
®
VLT
DriveMotor FCM Series
Illustration 3.1
3.1.4 Display
The LCD display is back lit and has a total of 4 alpha-
numeric lines together with a box that shows the direction
of rotation (arrow) and the chosen Set-up as well as the
Set-up in which programming is taking place if that is the
case.
Illustration 3.2
®
MG03BA02 - VLT
is a registered Danfoss trademark
Advertisement
Table of Contents
