Table of Contents
Advertisement
Copy: copy the channel configuration from one channel to another channel.
Paste: Paste the copied configuration to the channel.
Press Copy key in the source channel and press paste key in the destination channel.
5.1.2.1.1 Name
Enables the User to define the name for each channel with a maximum of 18 characters.
Select "Name", then Press "Enter", soft key, a keyboard with several keys will appear. Press "Shift" to
select special characters. Press "Caps" to select capital letters. Press soft key "OK" after entering a new
channel name.
5.1.2.2 Desc
The description about a specific channel on the recorder.
5.1.2.3 Type
Type of Digital input. The digital input can be configured as Logic Level and pulse counter. To
select the type press the Type and then select the required type.
5.1.2.3.1 Logic Level
This selection activates digital logic, which is either one or zero with low frequency which is less
than 1Hz, such as an external relay.
5.1.2.3.2 Pulse Counter
This selection will allow the digital input to read the high speed pulse inputs up to 100 Hz. This is
useful to get the flow rate from pulse output from flow meters.
Page 85 of 479
Advertisement
Table of Contents
