Table of Contents
Advertisement
6.2.3.3.9 Auto Configuration
The Auto configuration will automatically configure the tags from recorder, IO Module and
controllers. This will simplify the project setup procedure.
Device type: Select Recorder (PR) for addition of Recorder into network
Bank: Select bank from 1 to 4 as per bank configuration
Auto-update: Select if it is required to acquire data base of Recorders and give tag name for the channels
automatically
IP Address: IP address of the Recorder. After Entering the IP address press '+' to add to IP List.
IP List: IP List of the Recorders. If any recorder needs to be removed from the list then select the IP
address from the list then press'-' to remove the IP from the list.
Use Converter: Device Node Address: If the device is connected to PC via PC-E converter then select this
option and enter the node address of the device.
From: Start address of device in RS485 network.
To: End address of device in RS485 network. This is not applicable for Recorders.
Click on "OK" to add all the Recorders into network configuration
Page 266 of 479
Advertisement
Table of Contents
