Table of Contents
Advertisement
The below four kinds of combination are allowable for connecting segments.
Ramp-Ramp
Ramp-Dwell
Dwell-Ramp
Dwell-Dwell
5.2.5.2 Name
Enable the user to define the name for each Profile with the maximum limit of 18 Characters.
Select "Name", then Press "Enter", soft key, a keyboard with several keys appears. Press "Shift" to select
special characters. Press "Caps" to select capital letters. Press soft key "OK" after entering a new Profile
name.
5.2.5.3 Segments
The user can add or Insert or Remove the segments of the Profile in this section. Press Add
and then press Enter Soft key to access the Segment Configuration window.
5.2.5.3.1 Type
Select the Segment type. The Available segment types are as below.
1 Ramp
2 Time to Target
3 Dwell
4 Go Back
5 End
5.2.5.3.1.1 Ramp Segment Parameters
Condition
The condition to be selected for Ramp Segment to follow to reach set point as Ramp and Set
point or Ramp and Time. The Ramp and Set point will change the set point to reach the Set point in that
segment in the Ramp Rate specified. The Ramp and Time will change the Set point based on the ramp
rate specified for the duration mentioned.
Rate
Ramp Rate of the segment to reach the set point .The Ramp Rate unit can be set for
/Sec./Min,/Hour. The Ramp Rate Value can be defined in value.
Page 154 of 479
Advertisement
Table of Contents
