Table of Contents
Advertisement
Safety
This recorder is compliant with the requirements of EN61010-1, UL 61010C-1 & CSA C22.2 No.
24-93. If the equipment is used in a manner not specified by the manufacturer, the protection provided by
the equipment may be impaired. Manufacturer is not liable for any damages incurred to equipment/personal
during installation or use of equipment as explained in this document. User must acquire sufficient
knowledge & skills prior to using equipment in the application and follow all the local standards & regulations
to meet safety requirements.
Warning Symbol
This document contains notices that you should observe to ensure your own personal safety, as
well as to protect the product and connected equipment. These notices are highlighted in the manual by a
warning triangle and are marked as follows.
The danger symbol indicates that death or severe personal injury may result if proper
precautions are not taken. Do not proceed beyond a warning symbol until the indicated conditions are fully
understood and met.
Before connecting the power cord, ensure that the power supply voltage matches the voltage
rating for the instrument.
Make sure to connect the protective grounding to prevent electric shock before turning ON
the power. Never cut off the internal or external protective grounding wire or disconnect the wiring of the
protective grounding terminal. Doing so will pose a potential shock hazard. Do not operate the instrument
when the protective grounding or the fuse might be defective. Also, make sure to check them before
operation.
❖ Do not operate the instrument in the presence of flammable liquids or vapours. Operation
of any electrical instrument in such an environment constitutes a safety hazard.
❖ Some areas inside the instrument have high voltages. Do not remove the cover if the power
supply is connected. The cover should be removed by our qualified personnel only.
❖ Using the instrument in a manner not specified in this manual can damage the instrument's
protection
❖ Keep signal and supply voltage wiring separated from one another. If this is impractical,
use shielded cables for signal wiring. Double insulation should be used for signal wiring
when the recorder is used with hazardous voltage.
❖ Do not use the recorder where there is high vibration or a high magnetic field. This could
cause damage or error of measurement.
❖ All maintenance or repairs should be carried out with power disconnected to avoid personal
injury or damage to the unit.
❖ In areas with conductive pollution, adequate ventilation, filtering and sealing must be
installed.
❖ When cleaning the recorder, handle carefully and use soft dry cloth. Avoid the use of
abrasives, or any sharp or hard objects which would damage the display.
❖ Do not operate the recorder if any part has been removed or disassembled. Consult your
nearest dealer at once.
❖ Static Electricity: Appropriate precautions must be taken when handling the recorder. The
circuit board components are susceptible to damage caused by electrostatic discharge.
Take static electricity precautions while handling and inserting USB memory into the
recorder.
Page 2 of 479
Advertisement
Table of Contents
