Table of Contents
Advertisement
9. Add the device to the project as per the connection.
9.1. Select Recorder (PR) as device type to read the data from PR series Recorder.
9.2. Select the Bank as per the connection and select the check box of Auto-update Tag
contents to update the tags automatically.
9.3. Configure the log speed and log method
9.4. Enter the IP address and press
any existing devices in the list and needs to be removed then select the IP address and
press
key to remove.
9.5. If the device is connected via Ethernet to RS485 converter PC-E then select the check
box use converter: Device Node Address and enter the node address of the device. If
multiple devices are connected via PC-E Converter then select the Set node range
check box and enter the starting and end node addresses.
9.6. Press OK to establish the communication and auto update the tags from the recorder.
key to add the device to the project. It there are
Page 269 of 479
Advertisement
Table of Contents
