Table of Contents
Advertisement
After input the value press ok, the user can see the below screen.
After successful calibration of offset value calibration the system will show the calibration
completed message.
Press Back key to exit the calibration Menu. The system will prompt the user to save the new
calibration or not. Select Yes to apply the new calibration to the channel and No to exit without saving the
calibration data.
5.16 Procedure to Upgrade and Restore Factory Default Settings
This procedure will allow the user to recover the device when the recorder application is not
running or malfunctioning like hanging. The below procedure should be followed to recover the device.
Power ON the Recorder while Pressing the Reset Button
Page 223 of 479
Advertisement
Table of Contents
