8.4.4.1 Transformation Disable
If the transformation is set to disable and the decimal point is '0' then the value received on the
register don't need any conversion. If the decimal value is set as "1", then the value must to be divided by
10 to match with the value in Math of PR. If the decimal value is set as "2", then the value must to be divided
by 100 to match with the value in Math of PR. If the decimal value is set as "3" then the value must be
divided by 1000 to match the value in Math of PR. If the decimal value is set as "4" then the value must be
divided by 10000 to match the value in Math of PR. If the decimal value is set as "5" then the value must be
divided by 100000 to match the value in Math of PR.
8.4.4.2 Transformation as value
If the transformation is set to value and table is configured with transformation table entries then
the below formulae to be used to convert the raw value of DWord register to actual math channel value.
Math value = (((Register value * (ScaleHi - ScaleLo)) / 4294967295) + ScaleLo)
The scale low and scale hi of the math channel can be referenced from transformation table
output values. For example, the transformation table configured as below.
Page 475 of 479