Voice Trigger - GRAUPNER HoTT MC-16 Series Programming Manual

VOICE TRIGGER

After selection of the desired menu line with the 
selection keys of the left or right four-way button ...
TELEMETRY
TEL.RCV. RCV CH1
SETTING & DATA VIEW
SENSOR SELECT
RF STATUS VIEW
VOICE TRIGGER
... and a subsequent tap on the center
right four-way button will open the selected sub-menu.
VOICE TRIGGER
REPEAT 10SEC
TRIG
VARIO
TRANSMITTER
RECEIVER
GENERAL MODULE
ELECTRIC AIR.MOD
VARIO MODULE
GPS
AIR ESC
Note:
The sensors displayed here vary according to the
information you have entered in the "SELECT SEN-
SOR" sub-menu; see page 252. The screen-shot
above shows the maximum number of options, cor-
responding to "all sensors selected".
REPEAT
VOICE TRIGGER
REPEAT 10SEC
TRIG
VARIO
TRANSMITTER
RECEIVER
In order to be able to start the voice output through
the headphone connection, at the very least the "RE-
PEAT" line must be assigned to a switch. The takes
254 Program description - Telemetry
place as described in the section "Physical control,
switch and control switch assignments" on page 68:
VOICE TRIGGER
REPEAT
M o v e d e s i r e d s w i t c h
t o O N p o s i t i o n
( e x t . s w i t c h : S E T )
SET key of the
VOICE TRIGGER
REPEAT
TRIG
VARIO
–––
TRANSMITTER
–––
RECEIVER
–––
With this switch you can have the last respective
voice trigger repeated for the duration of the time
set to the left of the switch, as long as the assigned
switch is closed.
Simultaneously pressing the Select buttons  or
 of the right-hand four-way button (CLEAR) resets
the time value to "1 SEC.".
TRIG
With a switch assigned to this line, preferably a push-
button, switch the selected voice messages in rotation
on to the next voice message for the below-described
"TRANSMITTER", "RECEIVER" and "SENSOR" op-
tions.
–––
VOICE TRIGGER
–––
REPEAT
–––
TRIG
VARIO
TRANSMITTER
RECEIVER
VARIO
If the "VARIO MODULE" line is activated (
»SENSOR SELECT« sub-menu, as described on
10SEC
page 252, a switch assigned to one of these lines
can be used to call up vario-specific voice messages
for the headset connection which are completely
independent of other voice messages, i. e. voice
messages triggered by altitude changes, such as the
message "slowly ascend/descend":
10SEC 7
–––
–––
TRANSMITTER
After selection of the desired menu line with the 
selection keys of the left or right four-way button ...
... and a subsequent tap on the center
right four-way button will open the selected sub-menu.
5SEC 7
8
–––
Here, after selection of the desired line with the 
selection keys of the left or right four-way button and
a subsequent tap on the center
) in the
VOICE TRIGGER
REPEAT 5SEC 7
TRIG 8
VARIO 15
TRANSMITTER
RECEIVER
VOICE TRIGGER
REPEAT 10SEC 7
TRIG 8
VARIO 15
TRANSMITTER
RECEIVER
SET key of the
TX VOLT:
MODELTIME:
BATTERYTIME:
TIMER(GE.)TOP:
TIMER(GE.)CENTER:
PHASE TIMER:
TIME:
SET key of the right