Voice Trigger - GRAUPNER mx-16 HOTT Programming Manual

VOICE TRIGGER

VOICE TRIGGER
First select the desired menu line using the arrow but-
tons of the left or right-hand touch-key ...
TELEMETRY
SETTING & DATA VIEW
SIMPLE DATA VIEW
RF STATUS VIEW
VOICE TRIGGER
... then press the central SET button of the right-hand
touch-key to open the selected sub-menu:
REPEAT
VOICE TRIGGER
REPEAT 1SEC
TRIG
VARIO
TRANSFER
RECEIVER
Speech output is available via the headphone socket,
but not until you have at least assigned a switch in the
"REPEAT" line. This is accomplished as described in
the section entitled "Assigning switches and control
switches" on page 39:
VOICE TRIGGER
REPEAT 1SEC
push desired switch
into position ON
TRANSFER
RECEIVER
VOICE TRIGGER
REPEAT
TRIG
VARIO
TRANSFER
RECEIVER
All the time the assigned switch is closed, the last
speech output is repeated for the period set to the left of
the switch.
TRIG
Using a switch assigned to this line - preferably one of
the two momentary switches SW1 or SW 9 - you can
cycle through the speech outputs selected under the
"TRANSFER", "RECEIVER" and "SENSOR" options, as
–––
–––
described in the following section.
–––
VOICE TRIGGER
REPEAT
TRIG
VARIO
TRANSFER
RECEIVER
VARIO
If you assign a switch in this line, and activate the "RX
+ VARIO" sub-menu of the "DISPLAY DATA" menu (as
described on the next page under "Sensor") you can use
the switch to call up vario-specifi c voice outputs via the
earphone socket - completely independently of the other
voice outputs. These might be those triggered by altitude
changes, such as "slow climb / descent" etc.
VOICE TRIGGER
1SEC 3
–––
–––
TRANSFER
Select the desired menu line using the arrow buttons
of the left or right-hand touch-key ...
VOICE TRIGGER
1SEC 3
... then briefl y press the central
9
hand touch-key to open the selected sub-menu:
–––
In this menu you can select and de-select the chosen
speech output after using the arrow buttons
left or right-hand touch-key to select the desired line,
followed by a brief press of the central
right-hand touch-key:
REPEAT 1SEC 3
TRIG 9
VARIO 8
TRANSFER
RECEIVER
REPEAT 1SEC 3
TRIG 9
VARIO 8
TRANSFER
RECEIVER
SET button of the right-
VOLT:
MODELTIME:
BATTERYTIME:
STOPWATCH:
RUNTIME:
TIME:
SET button of the
Program description: Telemetry menu
of the
131