Table of Contents
Advertisement
ever, their assignment in the »Control adjust« menu
is possible only when the trainer mode connection is
inactive.
Use the selection keys of the left or right four-
way button to select the function inputs 1 through
max. 12 for transfer to the pupil () then briefly tap
center
SET
key of the right four-way button for each
switch to be switched between "Teacher" ( ) and
"Pupil" ( ):
Teacher / Pupil
Pupil
Teacher
1
2 3 4 5
SW: –––
BIND:
To be able to carry out the transfer, you must now
assign a trainer mode switch. Do this by placing the
marker frame just to the right of the "SW:" at the bot-
tom left of the screen display by using the selection
keys of the left or right four-way button then assign a
switch as described in the section "Physical control,
switch and control switch assignments" on page 68.
Preferably you should utilize a momentary switch to
allow a return of control to the teacher transmitter at
any time:
Teacher / Teacher
N o
–
Pup
p u p i l
s i g n a l
Teac
7
8 9 10 11
SW:
8
BIND:
Since at this stage of programming the wireless
trainer system no connection yet exists to a pupil
transmitter, the transmitter responds immediately to
the switches closed during the switch assignment
process with appropriate visual and audible warning
notices. You should therefore re-open the switch you
have just assigned:
Pupil
Teacher
SW:
Note:
The switch assignment just described also deter-
mines the transmitter used to issue the teacher and
pupil functions, respectively. For this reason, a pupil
transmitter must NEVER be assigned a switch on
this menu. The header line therefore also switches
6
from "Teacher / Pupil" to "Teacher / Teacher" once
n/a
a switch has been assigned.
Using the selection keys on the left or right four-way
button, now move the marker frame to the right, to
"BIND: n/a":
Pupil
Teacher
SW:
Binding the pupil transmitter to the teacher trans-
mitter
Note:
The distance between the two transmitters should not
12
n/a
be too great during the binding process. If necessary,
change the positions of the transmitters and initiate
the binding process again.
Initiate the "BINDING" process from the pupil trans-
mitter by tapping the center
way button ...
Teacher / Teacher
7
8 9 10 11
12
8
BIND:
n/a
Teacher / Teacher
7
8 9 10 11
12
8
BIND:
n/a
SET
key of the right four-
Teacher / Pupil
Pupil
Teacher
1
2 3 4 5
SW: –––
BIND:
Binding
... and repeat this immediately on the teacher trans-
mitter:
Teacher / Teacher
Pupil
Teacher
7
8 9 10 11
SW:
8
BIND:
Binding
As soon as this process is complete, both screens will
show "ON" instead of the flashing "BINDING":
Teacher / Pupil
Pupil
Teacher
1
2 3 4 5
ON
SW: –––
BIND:
Teacher / Teacher
Pupil
Teacher
7
8 9 10 11
SW:
8
BIND:
ON
You can return to the basic display on both screens
and start the training session after carefully checking
all of the relevant functions.
If neither transmitter or only one transmitter displays
"ON", this means the binding process has failed: try
changing the positions of both transmitters and then
repeat the entire procedure.
Program description - Teacher/pupil
6
12
6
12
227
Advertisement
Table of Contents
