Table of Contents
Advertisement
Detail program description
Loading a new memory location
Anyone who has worked through to this part of the
manual has certainly already tried out a bit of pro-
gramming. Nevertheless a detailed description of
every menu should not be left out.
This section begins with the loading of a "free" memo-
ry location, a procedure which would be performed if
a new model was being "programmed":
Stp
#01
Flt
4.1V
0:00h
M
From the basic display, a jump to the "Multi-function
list" is made with a tap on the center
right four-way button. (The center
ESC
four-way button will cause a jump back to the basic
display.) By default, when the multi-function list is
called for the first time after switching on the transmit-
ter, the »Model select« menu option will be active
and displayed in inverse video. Otherwise use the
or selection keys of the left or right four-way
button to select the »Model select« menu option,
whereby the upper of the two following figures shows
a selection list for a fixed-wing model and the lower
shows the selection list for a helicopter model.
Model select
Copy / Erase
Suppress menus
Suppress models
Base setup model
Model type
76
Program description - Loading a new memory location
Tap briefly on the center
0:00
button to open this menu option:
0:00
01
02
HoTT
03
0.0V
04
05
06
SET
key of the
In the transmitter's delivered state, the first model
key of the left
memory is initialized to the "fixed-wing model" type
and the receiver in the delivery is "bound" to this
model. This is indicated by the pictogram of a fixed-
wing model aircraft in the second column from left,
and the receiver identification displayed at far right; in
the example above this is R12. If the model memory
is not "bound", you will see "---" instead of the receiver
identification.
The remaining memory locations, marked with
"free", are still unoccupied and therefore
also "non-bound".
If you wish to program a fixed-wing model then,
after leaving the »Model select« menu with a tap
on the center
programming of the model can begin right away ... or
now use the or keys of the left or right four-way
button to select one of the free memory locations ...
Model select
Copy / Erase
Suppress menus
Suppress models
Base setup model
Helicopter type
SET
key of the right four-way
R12
free
free
free
free
free
ESC
key of the left four-way button,
01
02
free
03
free
04
free
05
free
06
free
... and then tap on the center
SET
four-way button to confirm the choice.
Afterward you will be prompted to select the basic
model type, i. e. either "winged model" or "helicopter
model":
Select model type
Use the or keys of the left or right four-way
button to select the basic model type then tap on
the center
SET
key of the right four-way button. This
initializes the selected model memory with the se-
lected model type and the display will return to the
base screen. The memory location is now accordingly
occupied.
Changing over to another model type is still possible if
you first erase this memory location (»Copy / Erase«
menu, page 80).
Notes:
•
If the currently active model memory is to be
erased then immediately after the erase action
one of the two model types, "Winged" or "Heli"
must be defined. You cannot avoid this selec-
tion even if you switch the transmitter off. Only af-
terward the undesired occupation of that model
memory erase from another memory location.
If a non-active memory location is erased, it will
R12
key of the right
Advertisement
Table of Contents
