Table of Contents
Advertisement
Notice for those transitioning from older Graup-
ner systems:
In comparison to previous receiver layouts, servo
connector 1 (pitch servo) and servo connector 6
(throttle servo) have exchanged places.
Installation notices
Servos MUST be connected to the receiver in the
sequence illustrated here.
Outputs which are not used are simply left empty.
For more detailed information on each swashplate
type please refer to the »Helicopter type« menu,
described on page 108.
Also be sure to follow the notices on the next
pages.
Note:
A speed control is also to be connected to receiver
output "6" in order to take full advantage of the throttle
limiter's convenience and safety features. See page
193 about this.
Receiver allocation for helicopter models with
1 to 3 swashplate servos
Free or aux. function
Free or aux. function
Free or speed governor or aux. function
Free or aux. function
Receiver power supply
Gyro gain
Throttle servo or speed controller
Free or aux. function
Tail rotor servo (gyro system)
Pitch-axis 1 servo
Roll 1 servo
Collective pitch or roll 2 or
Pitch-axis 2 servo
Receiver power supply
Free or aux. function
Receiver allocation for helicopter models with
4 swashplate servos
Free or aux. function
Free or aux. function
Free or speed governor or aux. function
Free or aux. function
Receiver power supply
Gyro gain
Throttle servo or speed controller
Pitch-axis 2 servo
Tail rotor servo (gyro system)
Pitch-axis 1 servo
Roll 1 servo
Roll 2 servo
Receiver power supply
Free or aux. function
All menus relevant to helicopter models are marked
in the „program descriptions" section with a helicopter
symbol ...
... so only these menus need to be dealt with to pro-
gram a helicopter model.
Helicopters - Receiver layout
75
Advertisement
Table of Contents
