press
18. RF STATUS VIEW
It shows RF status between transmitter and receiver through telemetry function.
Press DOWN button to go to RF STATUS VIEW line and press ENT button to access to RF
STATUS VIEW mode. You may check RF status at this screen.
press
70
press
ENT
TEL
VIW
ESC
ENT
TEL
VIW
ESC
press
19. VOICE TRIGGER
ENT
TEL
VIW
It is used to program the sensors related with voice function. The default article
ESC
REPEAT, TRIG, VARIO, TRANSSMITTER, RECEIVER are available and the optional
sensors could be attached. If the optional sensor is connected, it is need to add the
function for the optional sensor at SENSOR SELECT mode then VOICE TRIGGER
article is created. The useable sensors are GENERAL MODULE, ELECTRIC AIR MOD-
ENT
ULE, VARIO MODULE, GPS, AIR ESC.
TEL
VIW
ESC
- REPEAT
You may set the time and switch and if the switch is on, one of voice functions is
repeated for the setting time. Press DOWN buttons to go to VOICE TRIGGER line and
press ENT button then the default value 10sec on REPEAT is highlighted. Press UP/
DOWN buttons to set the desired value and press ENT button to remove the highlight.
Press the direction button to highlight the hyphen mark then press ENT button. The
popup message "push desired switch into position on" is appeared. Operate the switch
to be used as REPEAT on/off, that switch is designated as REPEAT on/off. After all
process, REPEAT function is operated when the switch is on.
ENT
TEL
VIW
ESC
press
press
ENT
TEL
VIW
ESC
ENT
TEL
VIW
ESC
ENT
TEL
VIW
ESC