GRAUPNER HoTT MC-16 Series Programming Manual page 305

After the switch assignment is complete, use the se-
lection keys to switch to the bottom right and activate
the assignment of phase names with a brief tap on
the center SET key of the right four-way button.
Now close for example switch "6" by moving the se-
lected 3-way switch forward.
Assign the name "<2 Thermal>" to this switch position
and leave the name of its "OFF" position as "<1 nor-
mal>".
Phase assignment
prior combi
A B C D
6 5
2 Ther malv
Phase assignment
prior combi
A B C D
6 5
1 nor mal
Finally, move the 3-way switch to the rear toward
"5"-position and assign this switch position the name
"<3 Speed>":
Phase assignment
prior combi
A B C D
6 5
3 Speed
The phase names selected in the programming are
now shown, depending on the switch status, in all
flight-phase dependent menus, see the table on
page 150.
Since we have already made some settings in flight-
phase dependent menus, such as in the »Wing
mixers« menu, we will now copy these settings to the
«Thermal» flight phase. For this purpose, open the
menu ...
»Copy/Erase«
... and switch to the "Copy flight phase" line:
E F
All seven possible flight phases are listed in "Copy
from phase":
Select the flight phase to be copied, e. g. "1 Normal".
E F
With a brief tap on the center
four-way button, switch the window to entry of the
target memory "Copy to phase".
Select phase "2 Thermal" as the target:
E F
Confirm the selection with a brief tap on the center
SET key of the right four-way button.
A security query follows, who should be confirmed
with "Yes":
(page 80)
=>
Erase model
=>
Copy model–>model
Expor t to SD =>
=>
Impor t from SD
=> =>
Copy flight phase
Copy from phase:
1 nor mal 2 Ther mal
3 Speed 4
5 6
7
SET key of the right
Copy to phase:
1 nor mal 2 Ther mal
3 Speed 4
5 6
7
Phase to:
1 Normal 2 Thermal
to be copied?
NO YES
Then repeat the process with flight phase "3 Speed".
Now we will program the required settings in the
flight phase "Thermal" as an example.
In order to vary camber flap positions in the «Ther-
mal» phase, it is merely necessary to switch over to
the menu ...
»Control adjust«
... then change Input 6 – as described beginning on
page beginning on page 118 – from "GL(obal)" to
"PH(ase)" and finally assign it to an operating ele-
ment.
To do this, first use the selection keys to switch into
the "typ" column for "In6" and change this setting from
"GL" to "PH":
In6 PH fr –––
In7 GL fr –––
In8 GL Cn1 –––
In9 GL ––– 8
Thermal
typ SEL
Thereafter change one column to the right into the
column above SEL ...
In6 PH fr –––
In7 GL fr –––
In8 GL Cn1 –––
In9 GL ––– 8
Thermal
typ SEL
... and now assign this input, as described in the sec-
Programming examples - Using flight phases
(page 118)
0%
0%
0%
0%
offset
0%
0%
0%
0%
offset
305