Volvo Edc3; Volvo Edc4 - Smartgen HGM6100LT SERIES User Manual

13.16

VOLVO EDC3

Suitable engine control mode is TAD1240, TAD1241, and TAD1242.
Terminals of controller
Programmable output1
Start relay output
Configurable output 2
Terminals of controller
CAN_SCR
CAN(H)
CAN(L)
Engine type: Volvo
NOTE: When this engine type is selected, preheating time should be set to at least 3 seconds.
13.17

VOLVO EDC4

Suitable engine types are TD520, TAD520 (optional), TD720, TAD720 (optional), TAD721, TAD722, and
TAD732.
Terminals of controller
Programmable output1
Start relay output
CAN_SCR
CAN(H)
CAN(L)
Engine type: VolvoEDC4
HGM6100LT Genset Controller
HGM6100LT Series Genset Controller User Manual
Table 35 – ―Stand alone‖ Connector
―Stand alone‖ connector
H
E
P
Table 36 – ―Data bus‖ Connector
―Data bus‖ connector
-
1
2
Table 37 - Connector
Connector
Expanded 30A relay, and
relay offers battery
voltage to terminal
14.Fuse is 16A
-
1
-
12
13
2018-10-26
Remark
Set configurable output 1 as ―Fuel Relay
Output‖
ECU power
Configurable output 2,"ECU power"
Remark
CAN communication shielding line
Using impedance 120Ω connecting line
Using impedance 120Ω connecting line
Remark
Set configurable output 1 as ―Fuel Relay
Output‖
Connect to starter coil directly
Connected to negative of battery
CAN communication shielding line
Using impedance 120Ω connecting line
Using impedance 120Ω connecting line
Version 1.0 Page 43 of 45