Sensor Setting - Smartgen HGM6100LT SERIES User Manual

Press and

9 SENSOR SETTING

— When choosing sensor, standard of sensor curve will be needed. If temperature sensor is set as
SGH (120º C resistor type), sensor curve should be SGH (120
(120º C resistor type), sensor curve should be SGD curve.
— If there is difference between standard sensor curve and chosen sensor curve, select ―defined
sensor‖, and then input defined sensor curve.
— When sensor curve is inputted, X value (resistance) must be in accordance with the order of higher
to lower, otherwise errors will occur.
— When sensor is selected as ―Not used‖, temperature, pressure and fuel level will be display as‖ - - -‖
in LCD.
— If there is no pressure sensor, but only has low pressure alarm switch, then you must set pressure
sensor as ―Not used‖, otherwise oil pressure low alarm shutdown may appear.
— Can set several points of forehand or backmost as the same ordinate, as the following picture:
1N/m
1Pa
2
1kgf/cm 9.8x10
1bar
1psi 6.89x10
HGM6100LT Genset Controller
(or and ) can adjust LCD contract. Adjustment range is 0-7.
Table 12 - Conventional pressure unit conversion table
2
(pa) 1kgf/cm
1 1.02x10
4
5
1x10
3
7.03x10
2018-10-26
HGM6100LT Series Genset Controller User Manual
o
2
－ 5
1x10
1
1.02
－
2
6.89x10
Version 1.0
C resistor type); If it is set as SGD
1bar (1b/in
－ 5
1.45x10
0.98
1
－
2
Page 31 of 45
2
) psi
－ 4
14.2
14.5
1