Manual Start/Stop Operation; Emergency Start - Smartgen HGM6100LT SERIES User Manual

4.4 MANUAL START/STOP OPERATION

1) HGM6120LT, Manual Mode is active when press
the modes, press
high speed running. If there is high temperature, low oil pressure, over speed and abnormal voltage
during genset running, controller can protect genset to stop (detail procedures please refer to
No.4~9 of Auto start operation). Under Manual Mode, switch won't transfer automatically, it is
necessary to press
2) HGM6110LT, Manual Mode is active when pressing
press to start genset, it can automatically detect crank disconnect and accelerate to high
speed running. If there is high temperature, low oil pressure, over speed and abnormal voltage
during running, controller can protect genset to stop quickly (detail procedures please refer to
No.4~9 of Auto start operation). After genset runs well in high speed, press
3) Manual stop, pressing
No.3~7 of Auto stop operation).

4.5 EMERGENCY START

In manual mode, pressing
whether the controller has started successfully according to disconnect conditions and the disconnection of
starter needs to control by operators. When operators observed the genset has started successfully, loose
the keys and the controller enter safety delay with start stops to output.
HGM6100LT Genset Controller
to start genset, it can automatically detect crank disconnect and accelerate to
to transfer load.
can shut down the running genset (detail procedures please refer to
can compel genset to start. The controller won't judge
and
2018-10-26
HGM6100LT Series Genset Controller User Manual
and its indicator illuminates. Under both of
, and its indicator is illuminating. Then
Version 1.0
and gens take load.
Page 12 of 45