SBC PCD1 Series Manual page 66

Saia-Burgess Controls AG
It is also possible to copy the application to the flash card independently of any down-
load, or conversely, to copy the application from the flash card to the Saia PCD
relevant menu options can be found under Online, Flash Card:
Before copying, the controller must be moved into the STOP state; where applicable,
an appropriate reminder will be displayed. The copying process may take up to 30
seconds.
3.17.3 Transferring an application
With the flash card, it is possible to transfer an application from a PCD2.M170/M480
to another controller of the same type:
● On the source controller,copy the application to the flash card as described in the
preceding sections
● Remove the supply to the source controller, and unplug the flash card
● Send off the flash card where applicable
● Ensure that there is no supply voltage to the target controller, then plug in the flash
card
● Switch on the supply to the target controller, then hold down the LOAD switch on
the flash card for at least three seconds; this can be done at any time
● Wait until the controller has restarted
Manual Manual PCD 1 / PCD 2 Series │ D ocument 26 / 737 EN22 │ 2 013-11-26
CPUs and expansion housings
Backup of the user program
. The
®
3
3-49