SBC PCD1 Series Manual page 219

Saia-Burgess Controls AG
Changing the jumpers
There are components on this circuit board, that are sensitive to electrostatic discharges.
For further information, refer to
Range selection (PCD2.W610)
Jumpers, factory settings: A0 ... A 3:
Ranges depending on application:
Per module: U/B:
Per channel:
Current outputs have been laid out for unipolar mode. Bipolar mode is possible, but
for the negative half of this operation the output is 0 mA.
Connection concept
Connection for 0 ... 1 0 V or -10 V ... + 10 V:
D
A
Connection for 0 ... 2 0 mA:
D
A
An external 24 V
Manual Manual PCD 1 / PCD 2 Series │ D ocument 26 / 737 EN22 │ 2 013-11-26
Appendix B,
U/B:
Reset select: "mid" (reset to mid-scale,
Reset select:
Rec. setting:
(PCD2.W610 only)
Contrôle de la
tension de la
source de
courant
supply is required for current outputs.
DC
"Icons".
"V" (voltage)
"B" (bipolar)
i.e. 0 V in bipolar mode)
Unipolar or Bipolar operation
Reset to low- or mid-scale
Unipolar →low-scale
Bipolar → mid-scale
"V" Voltage output:
0 ... + 10 V or -10 V ... + 10 V
"C": Current output:
(selectable on the PCD2.W610)
4 (A2)
U
5
R ≥ 3 kΩ
+ 24 VDC
4 (A2)
I
5
R = 0.. 500 Ω
Input/output (I/O) modules
Analogue output modules
0 ... 2 0 mA
5
5-83