Maintenance - InfraTec VarioCam Operating Instructions Manual

Operating Instruction for VarioCAM® head

12 Maintenance

Maintenance
12
Cleaning
The possible maintenance work on the VarioCAM
The optical faces of the lens are provided with high-quality optical coatings. Do not touch
these areas and protect them against dirt and damage. Always replace the proper cover on
the lens when the camera is not in use.
Nevertheless, if cleaning the optic faces should become necessary, please only use woodfree cotton or
Kleenex Professional Wipes Kleenex in combination with 96% ethanol.
For severe soling, please contact the manufacturer.
If the lens has been unscrewed (lens replacement), the opening of the camera casing must
be protected against any kind of contact with the internal components. It must be ensured,
that no contamination penetrates the inside of the camera. Any kind of intrusions in to the
inside of the camera are expressly prohibited.
Maintenance and repair work described in this instruction manual must only be performed by authorised
qualified staff. Non-compliance voids the manufacturer's guarantee and liability.
Calibration
®
The VarioCAM head system was very carefully calibrated at the manufacturer in compliance with the
national standard.
It is recommended to have the calibration checked by the manufacturer or another certified institution
every two years. This check should be combined with general device maintenance.
Operating Instructions
®
head is limited to the cleaning of external surfaces.
© InfraTec GmbH 2007 105