User Interface - InfraTec VarioCam Operating Instructions Manual

Operating Instruction for VarioCAM® head
10 IRBIS® remote Software

User Interface

Fig. 164 Program user interface IRBIS
Depending on the activated components (see chapter 10.1
interface can vary. If all components are activated, the view shown in Fig. 164 appears. If only the
analogue video component is activated, the parts for remote control of the camera are removed and the
window shown on the left of Fig. 164 is displayed. If only the part necessary for remote control and
without the analogue video display, the appearance is like that shown on the right Fig. 164.
Fig. 165 Toolbar with special buttons
An additional change in the appearance happens if the "Special Buttons" were disabled in the
configuration. Then, the toolbar shown in Fig. 165 is not displayed. As a result, the corresponding
functions are not available.
The "normal" user interface (Fig. 164) is made up of three areas
special buttons, and button emulation for remote control.
The analogue video display only displays the image supplied by the camera. The size of the displayed
image can be toggled between ordinary and enlarged resolution (see chapter 10.1
Both the areas related to remote control
control are described in detail in the following Section.
Operating Instructions
â
remote
toolbar with special buttons and button emulation for remote
© InfraTec GmbH 2007
page 67), the appearance of the user
analogue video display, toolbar with
page 67).
77