Menu "Measurement - InfraTec VarioCam Operating Instructions Manual

Operating Instruction for VarioCAM® head
11 Software IRBIS®

11.14 Menu "Measurement"

The "Measurement" menu contains the "Definitions ..." menu item. If this menu item is selected, a
dialogue box with the tabs Measuring Points and Measuring Areas is opened, where the measuring
points defined via the toolbar are displayed and their emissivity can be modified or deleted from the
thermal image.
Measuring Points tab
The "Measuring Points" tab is used for the display of the defined measuring points in the thermal image
and for the display of the temperature at the cursor.
Fig. 187 Dialogue "Measuring" Fig. 188 Dialogue "ROI"
The currently defined measuring points are displayed line by line in a table. All the measuring points set
are listed in this table and can be modified with respect to their emissivity. For this, a context menu is
opened by clicking on the desired menu item with the right mouse and then selecting the
"Edit epsilon..." context menu entry. The measuring point can be deleted with the "Clear" context menu
item. The "Clear all" button removes all measuring points from the thermal image.
The defined measuring areas are displayed on the Measuring Area tab and can be corrected with respect
to their emissivity.The type, the average value, the minimum, the maximum, and the standard deviation
are displayed for the defined measuring areas of the thermal image in the "Measured area 1"/
"Measured area 2" section. The corresponding measuring area can be deleted using the "Delete"
button. The emissivity can be modified in the "Emissivity" input field.
Operating Instructions © InfraTec GmbH 2007 97