Configuration - InfraTec VarioCam Operating Instructions Manual

Operating Instruction for VarioCAM® head
10 IRBIS® remote Software

10.1 Configuration

First start and mandatory configuration
®
Fig. 142 IRBIS remote configuration
After starting the program for the first time or after starting the program from the Start Menu, the dialog
shown above is displayed, which is used for quick program configuration.
Category "Language"
The language for the remote control software interface can be switched between "German" and
"English".
Category "Components"
The components to be used can be set here. The remote control software is able to communicate with
the camera via an RS232 interface and a display of the analogue video signal. If part of this functionality
is not required (e.g. because the corresponding hardware is not available), it can be disabled here.
For the component selection, at least one of the components must be activated, otherwise
there would be no point in starting the program.
Operating Instructions © InfraTec GmbH 2007 67