InfraTec VarioCam Operating Instructions Manual page 74

Language, Components, Framegrabber, Resolution
Modifying these settings is done in the same way as described in the Configuration chapter 10.1
67.
Fig. 146 Dialogue "Falcon
In addition, there is a button "..." next to the Framegrabber settings "Falcon" entry "..." for configuring
the video input for the Falcon Framegrabber. If the button is pressed the dialogue shown in Fig. 146 is
displayed. The video input to be used can be set here. The changes are applied with "OK" and discarded
with "Cancel".
Timeouts for Initialisation
Fig. 147 Setting the timeouts for initialisation
In the category "Timeouts For Initialization" (see Fig. 143
waiting time in seconds for the initialisation of a component can be specified. For example, if no
framegrabber card is installed, yet the analogue video component is activated, then using the example
shown in Fig. 143 (Page 69), the establishment of such a connection will be attempted for a maximum of
15 seconds. After this, the initialisation is cancelled and the video components are automatically disabled.
The "Serial Communication [sec]" or "Video Connection [sec]" input field is disabled, if the
"Serial Communication" or "Video Connection" component in the "Components" settings
(see chapter 10.1
70
Video Settings"
Page 67) is disabled.
© InfraTec GmbH 2007
Operating Instruction for VarioCAM® head
10 IRBIS® remote Software
Page 69), the maximum permissible
Operating Instructions
page