InfraTec VarioCam Operating Instructions Manual page 44

Menu item "Config"
Fig. 87 Menu "Settings"
If the "Config" menu item is selected, a submenu is displayed, where it is possible to save or load the
camera configuration and to configure default settings.
Fig. 88 Dialogue "Load configuration"
It is possible to load a configuration with the
"Load.." option. (1-5)
Fig. 90 Dialogue "Start behaviour"
On selection of the "Start.." menu item, a dialogue is displayed (see Fig. 90), where the start behaviour
of the thermograph camera can be defined.
"Autofocus" The camera should automatically set the best focus for the scene on starting.
"AutoImage" Automatic adjustment of the temperature level and range at the scene.
"AutoLevel" Only the temperature level at the scene should be adjusted automatically.
"AutoCalib" The best calibration range corresponding to the scene temperature will be set on starting
the camera.
"FixLevel" Sets the temperature level setting to a fixed value of 20°C on starting the camera.
"FixSpan" The camera should set a fixed temperature range of 40K on starting.
"RS232" The communication via the serial port is initialised and activated on starting the camera.
The Enter key is pressed to save the settings, whereupon the dialogue also closes. If the changes made
should be discarded, press the C-key.
40
"Config"
Fig. 89
The "Save" option is used to save the current
configuration. (1-5)
© InfraTec GmbH 2007
Operating Instruction for VarioCAM® head
7 Menu structural VarioCAM® head
Dialogue "Save configuration"
Operating Instructions