InfraTec VarioCam Operating Instructions Manual page 22

Fig. 18 Status bar in the status "SPTPOS" (top), "SPTDIM" (middle), "SPTEPS" (bottom)
In Fig. 18 the status bars of the individual states are displayed for a rough overview of the possible
functions. These functions are described in more detail below.
Status "SPTPOS"
The "SPTPOS" status is reached after long pressing the T-button (TL) in the Live or Freeze display. The
position of the measuring areas can be changed here. This status is exited automatically after ca. 30 sec
of inactivity. The display then switches back to the previous display mode. The first time the
(no measurement area has been defined yet), a new Spot in approximately the centre of the infrared
image is generated automatically (see Fig. 19
Fig. 19 View of the Spot Editor with a standard measurement area
The joystick buttons are used to change the position of the current measurement area. In doing so, the -,
¯ buttons move the Spot vertically upwards or downwards. The ¬,
movement.
The next measuring area can be activated with the T-button. In doing so, the current measurement area
is displayed with a blue background.
A new measurement area is regenerated approximately in the centre of the screen, if
total of up to five measuring areas can be defined.
The C-button is used to delete a measurement area. If the last measurement area is deleted by doing
this, the last display mode is returned to.
The status "SPTDIM" is reached by pressing the A-button. This is used for establishing the dimensions of
the measurement area. This status is now explained in more detail.
18
Spot 1).
© InfraTec GmbH 2007
Operating Instruction for VarioCAM® head
7 Menu structural VarioCAM® head
®
buttons can be used for left or right
TL
Operating Instructions
TL is pressed
is pressed. A