Installation Of The Firewire Driver For Variocam ® Head Till Firmware-Version 2.093; Driver Installation Under Windows 2000 - InfraTec VarioCam Operating Instructions Manual

9.3 Installation of the FireWire driver for VarioCAM
Firmware-Version 2.093
Hardware preparation
®
The VarioCAM or the VarioCAM
computer or the notebook are connected with the supplied FireWire (IEEE 1394) cable. Afterwards the
computer or notebook and the thermography system must be switched on. If the boot process of the
computer or the notebook is completed and the thermography system is ready for operation, the
automatic Windows
hardware wizard. The integrated FireWire (IEEE 1394) interface makes the VarioCAM
peripheral which is recognised by the operating system and whose driver installation is started
automatically on first use.
Driver installation under Windows
9.3.1
The hardware drivers for the VarioCAM
successful installation of the IRBIS
been completed successfully, the hardware installation can be started with the Windows
hardware wizard:
Fig. 103 Microsoft Windows Found New Hardware Wizard
46
®
head (only the VarioCAM
hardware recognition reports "New hardware found" and starts the add new
®
are automatically copied into the "/driver" subdirectory with the
®
control software. If the installation of the IRBIS
© InfraTec GmbH 2007
Operating Instruction for VarioCAM® head
9 Hardware and Software Installation
®
is mentioned in the following) and the
2000
start dialogue
® head till
®
represent a PC
®
control software has
add new
Operating Instructions