Operation Via The Ieee1394 Interface; First Use; Connection Variocam ® Head - Pc/Notebook - InfraTec VarioCam Operating Instructions Manual

Operation via the IEEE1394 Interface

5.1.6
If necessary, first install the IEEE1394 interface card in the computer. Please refer to the accompanying
documentation for information about this. A 6-pole IEEE1394 cable is provided for connecting the camera
to the interface card. The appliance power supply comes from the PC in this configuration.
5.2

First Use

We recommend the following procedure for the first operation of VarioCAM
Remove the lens protective cover.
Verify that the battery or mains adapter is connected.
Switch on the camera by pressing the "C" button briefly.
The green LED on the back starts to flash.
The appliance is ready for use after approx. 40 seconds. The duration of the power-on process
depends on the ambient temperature.
Point the camera at a warm object and press the "A" button. This activates the Autoimage function, and a
thermal picture of the selected object appears in the viewfinder. Adjust the viewfinder to your eye using
diopters equalisation. For focussing on the distance of the object, press on the joystick briefly (focus
mode appears) and move the joystick upwards (far) or downwards (near).
5.3 Connection VarioCAM
The thermography system VarioCAM
FireWire (IEEE 1394) cabel.
The automatic hardware recognition reports to the first-time connection of the Thermography-camera with
the PC/Notebook. For further policy about the installation of FireWire (IEEE 1394)-drivers for VarioCAM
head, please refer to chapter 9.3, Installation of the FireWire driver for VarioCAM
Version 2.093 page 46.
12
®
head - PC/Notebook
®
head can be connected to PC/Notebook with the enclosed
© InfraTec GmbH 2007
Operating Instruction for VarioCAM® head
®
head:
®
head till Firmware-
Operating Instructions
5 Starting Up
®