Maintenance Of The Device; Cleaning; Calibration - InfraTec VarioCAM User Manual

11

Maintenance of the Device

11.1 Cleaning

Possible maintenance of the VarioCAM
The optical surfaces of the lens have been coated with high-value optical films. Do not touch these
surfaces and protect them against dust and from being damaged. If the device is not in use, protect
the lens by putting on its protective cover.
Should cleaning the optical surfaces become necessary, please exclusively apply woodfree cotton wool
or Professional Wipes Kleenex in combination with 96% ethanol.
If the device is heavily soiled, please turn to the manufacturer.
With the lens detached (during lens change), the opening of the camera housing is to be protected
against any kind of touching its internal components. Please take care that no impurities will get
into the camera. Any tampering with internal components of the thermographic camera is expressly
prohibited.
Any maintenance and repair beyond any activities described in this User Manual must only be performed
by authorised professionals. Any violation will void any warranty or any liability on the manufacturer's part.

11.2 Calibration

The system VarioCAM
compliance with the National Normal.
It is recommended to have the calibration checked by the manufacturer or any other certified body
approximately every two years. Along with this check, the device should undergo general maintenance
with the manufacturer.
84
User Manual for the Thermographic System VarioCAM
®
hr is limited to cleaning external surfaces only.
®
hr has very carefully been calibrated by the manufacturer, observing precision
© InfraTec GmbH 2013
® high resolution
11. Maintenance of the Device
User Manual