Process; Error Information - InfraTec VarioCam Operating Instructions Manual

8.3

Process

During the update all parts of the update are handled step by step (see Chapter 8.1). When the
respective file is found, the information as in Fig. 98 appears.
Fig. 98 Information for updating the thermographic camera
The progress of updating the respective part is to be seen in the status line.
Is the update of the respective part is finished the following information is displayed (see Fig. 99).
Fig. 99 Information about the successful finish of an update part
Is there no file for some update part the following information appears:
Fig. 100 Information if update part is missing
Each information is on display for about 5 sec. before the next part is updated. After all update parts are
passed resp. gone over the following information appears for 5 sec (see Fig. 100).
Fig. 101 Dialogue for finished update
Starting the camera again the update will be activated.
8.4

Error Information

Before the actual update the tool for updating the camera tries to deactivate all automatic functions which
could lead to any disconnection of the power supply. If this is not possible because of the current settings
of the camera the update will not be started and the following information is displayed (see Fig. 102).
Fig. 102 Dialogue in the case of cancellation of the update
Another try is possible. If several tries fail the camera should be started again.
44 © InfraTec GmbH 2007
Operating Instruction for VarioCAM® head
8 Execute camera update
Operating Instructions