Description Of The Thermography System Firewire (Ieee 1394) Connection; Description Of The Thermography System Power Supply - InfraTec VarioCam Operating Instructions Manual

Operating Instruction for VarioCAM® head
5 Starting Up
Description of the thermography system FireWire (IEEE 1394)
5.3.1
connection
Fig. 4 FireWire (IEEE 1394)
6-pole cable.
Fig. 5 FireWire (IEEE 1394)
4-pole cable.
Fig. 6 LEMO 6-pole connector
Fig. 7 LEMO socket
(6-pole and 14-pole)

Description of the thermography system power supply

5.3.2
Fig. 8 power supply
Fig. 9 Adapter P for adaptation of the 6-
pole power supply cable to 14-pole
Operating Instructions
1. A connection from thermography system to the PC is made
with the 6-pole FireWire (IEEE 1394) cable (Fig. 4). In doing so,
the 6-pole FireWire (IEEE 1394) cable must be connected with
an IEEE 1394 PCI card integrated in the PC.
A connection from the thermography system to the notebook
is made with the 4-pole FireWire (IEEE 1394) cable (Fig. 5). In
doing so, the 4-pole FireWire (IEEE 1394) cable must be
connected with the IEEE 1394 FireWire connection integrated in
the notebook.
(alternatively PCMCIA CardBus card)
2. There is a 6-pole LEMO connector (Fig. 6) at the other end of the
6-pole or 4-pole FireWire (IEEE 1394) cable.
3. The 6-pole LEMO connector is connected to the 6-pole LEMO
socket (Fig. 7) on the thermography system.
Please ensure the connection is made to the correct LEMO
socket!
Note: Plug the LEMO connector with the red dot at the top into
the socket. Do not apply excessive force.
When operating the thermography system on a notebook
(FireWire connection without electricity supply), this must
be connected to the 6-pole LEMO socket (Fig. 7) via a
power supply (accessory).
Note: If the thermography system is operated without a
power supply on a PC, it must be ensured that the
FireWire cards recommended by Infratec are used.
Otherwise Infratec makes no guarantee of functionality.
1. The power supply is connected with the Adapter P
(Fig. 9) for using the 14-pole LEMO socket.
Please ensure you use the correct LEMO connector
(yellow marker)!
2. The 14-pole LEMO connector of the Adapter P
(Fig. 9) is connected to the 14-pole LEMO socket
(Fig. 7) on the thermography system.
Please ensure you use the correct LEMO socket!
© InfraTec GmbH 2007 13