Focus Mode; Spot Editor - InfraTec VarioCam Operating Instructions Manual

Operating Instruction for VarioCAM® head
7 Menu structural VarioCAM® head
7.2

Focus Mode

Focus Mode is reached with Enter.
Fig. 17 Focus-Modus
A greater object distance
displays the relative focus position. Moving the joystick in the
electronically. The zoom factor is reduced again with ¬. The zoom factor (1 to ca. 4.3) is displayed in a
bar. It must be pointed out, that the T-button in an electronic zoom leads to the measurement spot
display. TL opens the Spot Editor (see chapter 7.3
Enter switches back to Live Mode (see chapter 7.1
7.3

Spot Editor

The Spot Editor is reached from all other states via the T-button (TL).
It contains three states:
SPTPOS
SPTDIM
SPTEPS
These states are used for definition and processing of measurement spots or measurement areas.
A measurement area with the smallest possible resolution of 2x1 pixels is termed a measurement spot.
These can be used for selective temperature measurement. If the spot is enlarged, we are dealing with a
measurement area. Here it is possible to display a minimum or maximum temperature value and the
average temperature across the measurement area. For simplification, only the expression
"measurement area" will be used below.
Operating Instructions
-
or a smaller object distance
© InfraTec GmbH 2007
¯
can be focussed on using the joystick. A bar
®
- direction zooms the image
page 17).
page 16).
17