InfraTec VarioCam Operating Instructions Manual page 42

Menu item "A-key"
Fig. 80 Menu "Settings"
The "A-key" menu item is used to configure which actions should be executed when the A key is
pressed. The option "Compensation" and "Autoimage" in the submenu can be (de)activated for this. If
the option is activated, this is indicated with a checkmark.
An homogenisation of the image is performed for a "Compensation".
The "Autoimage" option provides automatic adjustment of temperature level and range. That means the
best settings for both these parameters are selected according to the content of the image for display.
Menu item "Compensation"
Fig. 81 Menu "Settings"
Fig. 81 shows the "Settings"
compensation parameters.
There is a choice of both "Shutter" and "Object/intern" types, and the current setting is marked with a
bullet. In the example shown in Fig. 81, the current compensation is set to the camera shutter.
Fig. 82 Dialogue "adjustment interval"
The interval for an automatic compensation is adjustable via the "Interval.." option. On selection of this
menu item, the dialogue shown in Fig. 82 is displayed. Here, the time in seconds, after which an
automatic compensation should always be performed, must be input. The limits for entering the interval
are 5 sec and approx. 16 min (995 sec). If the value entered exceeds or is below these limits, it is
adjusted automatically. However, the value 0 is a special case, which makes it possible to switch off the
automatic compensation.
38
"A-key"
"Compensation"
"Compensation" menu. This menu is used for setting the image
© InfraTec GmbH 2007
Operating Instruction for VarioCAM® head
7 Menu structural VarioCAM® head
Operating Instructions