InfraTec VarioCam Operating Instructions Manual page 85

Operating Instruction for VarioCAM® head
11 Software IRBIS®
Definitions of temperature profiles (not accessible from the menu)
Set Profile
After pressing the button, the cursor changes to a crosshair as soon as it is located on the thermal image.
If the menu item "Profile" in the "View" menu is not already activated, this happens automatically. In the
areas provided to the right of or below the thermal image, the vertical or horizontal temperature profile
corresponding to the current cursor position is displayed. During placement of the temperature profile,
you cannot exit from the thermal image window. Furthermore, no menu functions can be called either.
The crosshair is positioned by pressing the left mouse button which completes the definition of the
temperature profile. The temperature profile display can be removed by pressing the "Set Profile" button
in the toolbar again. Deactivating the menu item "Profile" in the "View" menu also results in automatic
removal of the temperature profile.
Arrangement of measuring or correction points (not accessible from the menu)
Set Point
Set Line
Set Rectangle
Set Ellipse
Set Circle
Set Polygon
After pressing the corresponding button, the cursor changes to a crosshair as soon as it is located on the
thermal image. Depending on the type selected, the placement of the measuring area is achieved as
follows:
Point: A measuring point can put anywhere in the thermal image by clicking the left mouse
button.
Line: Any starting point can be selected using the left mouse button. Afterwards the line is
drawn by holding down the left mouse button and dragging to the endpoint.
Rectangle: The starting point is selected using the left mouse button and the rectangle is "drawn"
by holding down the mouse button and dragging so that the endpoint is diagonally
opposite.
Ellipse: An ellipse can be drawn by dragging with the left mouse button in a similar procedure
to that for the rectangle. Release the mouse button afterwards.
Circle: A circle can be drawn by holding down the left mouse button and dragging from the
centre of the circle for the length of the radius. Release the mouse button afterwards.
Polygon: First click the left mouse button on one, then on all the other corner points, complete
the placement by clicking the right mouse button.
The thermal image window cannot be exited and no menu functions can be called for as long as the
measuring point setting is not complete. The measuring points set can be modified or deleted via the
Operating Instructions © InfraTec GmbH 2007 81