Danfoss VLT AutomationDrive FC 300 Series Programming Manual page 112

Parameter Descriptions
8-57 Profidrive OFF2 Select
Select control of the OFF2 selection via the terminals (digital
input) and/or via the fieldbus. This parameter is active only when
par. 8-01 Control Site is set to [0] Digital and ctrl. word and par.
8-10 is set to [1] Profidrive profile.
Option:
[0] Digital input
[1] Bus
[2] Logic AND
[3] Logic OR
*
8-58 Profidrive OFF3 Select
Select control of the OFF3 selection via the terminals (digital
input) and/or via the fieldbus. This parameter is active only when
par. 8-01 Control Site is set to [0] Digital and control word and
par. 8-10 is set to [1] Profidrive profile.
Option:
[0] Digital input
[1] Bus
[2] Logic AND
[3] Logic OR
*
3.10.6 8-8* FC Port Diagnostics
These parameters are used for monitoring the Bus
communication via the FC Port.
8-80 Bus Message Count
Range: Function:
0 [0 - 0 ] This parameter shows the number of valid
*
telegrams detected on the bus.
8-81 Bus Error Count
Range: Function:
0 [0 - 0 ] This parameter shows the number of telegrams
*
with faults (e.g. CRC fault), detected on the bus.
8-82 Slave Messages Rcvd
Range: Function:
0 [0 - 0 ] This parameter shows the number of valid
*
telegrams addressed to the slave, sent by the
frequency converter.
8-83 Slave Error Count
Range: Function:
0 [0 - 0 ] This parameter shows the number of error
*
telegrams, which could not be executed by the
frequency converter.
®
VLT AutomationDrive Programmming Guide
3.10.7 8-9* Bus Jog
8-90 Bus Jog 1 Speed
Range:
100 RPM
Function:
8-91 Bus Jog 2 Speed
Range:
200 RPM
Function:
®
MG33ME02 - VLT is a registered Danfoss trademark
Function:
[0 - par. 4-13 Enter the jog speed. Activate this
*
RPM] fixed jog speed via the serial port
or fieldbus option.
Function:
[0 - par. 4-13 Enter the jog speed. Activate this
*
RPM] fixed jog speed via the serial port
or fieldbus option.
3 3
111