Table of Contents
Advertisement
Programming
#
List of restricted numbers for ringing signals
Storing telephone numbers in the list of restricted numbers for
ringing signals
You can assign telephone numbers to 10 list entry locations (see also page 26 of the user
manual). The length of these telephone numbers is restricted to 20 digits as a maximum.
#
Remarks:
- A pre-requisite for the use of this function is that the caller's telephone number is trans-
ferred and presented (CLIP).
- You can erase a number within the programming process by pressing the redial key.
- You can enter dialling pauses by pressing the lower speed dialling key.
Activate/deactivate list of restricted numbers for ringing signals
At least one telephone number has to be stored in the list in order to be able to activate or
deactivate it (see last paragraph). If you deactivate the list of restricted numbers for ringing
signals, the telephone operates according to the standard ringing signal operation.
Press the P key and afterwards press the # key briefly.
Enter
code 30 for "standard ringing signal operation"
code 31 for „list of released numbers for ringing signal ON"
Press the P key. The entry is stored.
Press the P key and afterwards, press the # key (longer than 1 sec.).
Enter 4-digit-PIN.
Select the code of the desired list entry location and enter:
code 210 for list entry location 0
code 211 for list entry location 1
code 212 for list entry location 2. If desired, continue entering
locations up to code 219 for list entry location 9.
Enter telephone number.
Press the P key. The telephone number is stored.
24
or
Advertisement
Table of Contents
