Program Pause Duration After Dialling Eic/Psic - TIPTEL Ergophone C Programming Instructions Manual

Programming
tion, you need to program your telephone for dialling an external telephone number and for
dialling PABX extension numbers. You can enter 1 EIC number (1 - 4 digits) and 1 PSIC
number (1 - 4 digits). Please also refer to the PABX user manual.
#

Program pause duration after dialling EIC/PSIC

For the required pause after dialling the corresponding identification codes, you have the
option to program either short or long pauses (depends on the type of PABX). In the facto-
ry pre-set, the short pause is set (3 seconds). Please also refer to the PABX user manual.
The programmed duration of the pause is a maximum time. If the exchange dialling tone is
heard, the dialling procedure is initiated immediately.
#
Press the P key and afterwards, press the # key (longer than 1 sec.).
Enter 4-digit-PIN.
Enter
code 710 for „ EIC - Exchange Identification Code „ or
code 711 for „ PSIC Primery Station Identification Code „.
Enter EIC resp. PSIC via the key pad.
Press the P key. The setting is stored.
Press the P key and afterwards, press the # key (longer than 1 sec.).
Enter 4-digit-PIN.
Enter code 720.
Enter the duration of the dialling pause (in seconds) via the key pad
(1 - 9).
Press the P key. The setting is stored.
44