Program Pauses Between The Redialling Sequences; Program Number Of Redialling Sequences; Room Monitoring; Change Access Code For Room Monitoring - TIPTEL Ergophone C Programming Instructions Manual

Programming

Program pauses between the redialling sequences

#

Program number of redialling sequences

#

Room monitoring

You can monitor a room where your telephone is located - remotely (see also page 29 of
the user manual).

Change access code for room monitoring

The 4-digit access code for room monitoring is not included in the factory pre-set. This
code must be entered before the first use of this function. Then, you have the option to
change the code. The intial entry of the code and the change of the code is done according
to the following procedure:
Press the P key. The length of the redialling sequence is stored.
Press the P key and afterwards, press the # key (longer than 1 sec.).
Enter 4-digit-PIN.
Enter code 651
Enter ength of the pause between the redialling sequences via the
keypad (1 - 99 seconds).
Press the P key. The setting is stored.
Press the P key and afterwards, press the # key (longer than 1 sec.).
Enter 4-digit-PIN.
Enter code 652.
Enter the number of redialling sequences via the keypad
(00 - 99 seconds).
Press the P key. The setting is stored.
40
60 sec
P