Table of Contents
Advertisement
Programming
striction is on. Basically, the two telephone numbers are saved without any local area code
and, when connected to a PABX, without an EIC (Exchange Identification Code). Example:
In Germany, enter 110 for the police and 112 for the fire service.
#
Remarks:
- You can erase a number within the programming process by pressing the redial key.
- You can enter dialling pauses by pressing the lower speed dialling key.
- When the dialling restriction is activated, the police or fire service numbers can be
entered manually (Dialling from the speed dialling locations or abbreviated memory
locations is not possible in this case). If your telephone is connected to a PABX, then
you must first dial the EIC (Exchange Identification Code) (e.g. „0") and then the tele-
phone number of police or fire service. Take care that the EIC has been programmed.
Adjust display brightness
Your can adjust the display brightness with the digit keys 0-9. The higher the number, the
darker the display.
#
Press the P key and afterwards, press the # key (longer than 1 sec.).
Enter 4-digit-PIN.
Select and enter
code 611 for the „Police" memory location
code 612 for the „Fire service" memory location.
Enter telephone number
Press the P key. The setting is stored.
Press the P key and afterwards, press the # key (longer than 1 sec.).
Enter 4-digit-PIN.
Enter code 550.
Adjust the display brightness with the digit keys 0-9.
Press the P key. The setting is stored.
37
Advertisement
Table of Contents
