Activate/Deactivate Room Monitoring - TIPTEL Ergophone C Programming Instructions Manual

Ergonomic telephones
Hide thumbs Also See for Ergophone C:
Table of Contents

Advertisement

Programming
#
Remark:
It is not allowed to enter „0000" as an access code for room monitoring. If this number is
entered as access code, the procedure „Activate room monitoring" is aborted. Should you
have forgotten the access code, you can assign a new code via the above procedure.

Activate/deactivate room monitoring

The function „room monitoring" has to be activated at the telephone in the room to be
monitored (see also page 29 of the user manual). It can only be activated, if the access
code has been programmed.
#
Remarks:
- If you wish to have a „silent monitoring" without an earlier ringing signal, you just need
to deactivate the ringing signal. For an incoming call, the display will indicate this by
„call".
- When using the „silent monitoring", please observe the Data Protection Law.
Press the P key and afterwards, press the # key (longer than 1 sec.).
Enter 4-digit-PIN.
Enter code 660.
Enter 4-digit access code (r-PIN) (entry „0000" not allowed)
Enter 4-digit access code (r-PIN) again for confirmation.
Press the P key. The setting is stored.
Press the P key and afterwards press the # key brifly.
Enter
code 60 for „room monitoring OFF" or
code 61 for „room monitoring ON".
Press the P key. The setting is stored.
R-PIN
41
P

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ergophone cr

Table of Contents