Table of Contents
Advertisement
Initial operation
• Exchange inlay plate: Take the plastic cover at the top left side (handset rest) and pull it
in an upward direction. The cover comes out of the holder.
• If you intend to wall-mount the telephone, you have to remove the detent (removable
part of the upper housing) on the lower side of the pre-printed inlay plate, turn it round
and replace it in this position (see page 14).
Prepare radio pendant
If you have purchased the variant with distress radio system, the scope of supply com-
prises a radio pendant and a cord.
You can wear the radio pendant around your neck.
As an alternative, the radio pendant can be worn like a wristwatch. There are two long
loops at the back of the pendant where you can draw through a customary strap (see
illustration 4).
Put on dial pad cover
The dial pad cover serves as an aid for dialling. You can install and remove the cover as
desired. The dial pad cover is comprised in the scope of supply.
Ilustration 4 Radio pendant with strap
ATTENTION
Programm the radio pendant only after having connected the tele-
phone to the power supply system!
If the radio pendant is programmed, the radio receiver inside of the
telephone discharges the batteries very quickly, if the telephone is not
connected to the power supply.
12
Advertisement
Table of Contents
