Set Vital Sign Function On/Off; Operation At A Pabx; Program Recall Key; Program Eic/Psic - TIPTEL Ergophone C Programming Instructions Manual

Programming

Set vital sign function on/off

After setting the timer, the vital sign function has to be switched on by a code additionally.
If you do not need the function anymore, switch it off.
#

Operation at a PABX

Program recall key

You can adjust the recall key for four flash periods of different lengths. In the
factory pre-set the first flash (also known as hook flash) is set.
required e. g. to activate special features offered by the telecommunications provider.
Probably, the flash setting only needs to be programmed if the telephone is operated at a
telephone system (see operating instruction of your PABX).
#

Program EIC/PSIC

If you operate the telephone at a PABX, the exchange identification code and the primery
station identification code serve to program the required dialling pause. As for initial opera-
Press the P key and afterwards press the # key briefly.
Enter
Code 80 for „vital sign function off" or
Code 81 for „vital sign function on".
Press the P key. The setting is stored.
Press the P key and afterwards, press the # key (longer than 1 sec.).
Enter 4-digit-PIN.
Select code and enter:
code 700 for „Flash 1" (0,26 sec.= Hook Flash)
code 701 for „Flash 2" (0,09 sec.)
code 702 for „Flash 3" (0,11 sec.)
code 703 for „Flash 4" (0,13 sec.)
Press the P key. The setting is stored.
43
The long flash is